Yeah Man Drive
Sunday, December 16, 2012
Nissan Skyline GTR R35: After hearing about the development of the HKS Tur...
Nissan Skyline GTR R35: After hearing about the development of the HKS Tur...: After hearing about the development of the HKS Turbo Kit, one particular GT-R owner closely involved with the GT-R community was privv...
Saturday, November 10, 2012
Mechanic
Do you know how's some vehicles look like ?
With specific plans & scales?
Here are are some of the internal design made .
With specific plans & scales?
Here are are some of the internal design made .
Sunday, October 28, 2012
NOS Kit Number 5151
This is a very quick and basic article on how to install the NOS kit 5151, for the TPI equipped Camaro, Firebird, and Corvette. The information here is taken directly from the installation manual provided by NOS. Of course the manual is more detailed, but the point of this article is to give a brief explanation of installation procedures. A full installation manual can be purchased separately from NOS for $5.00. The manual is included with the setup.
Step 1: Mounting the Bottle
Step 2: Injector Plate Mounting
Step 3: Fuel feed lines
Step 4: Fuel and Nitrous solenoids
Step 5: Nitrous feed line routing.
Step 6: Throttle Micro-Switch Installation
Step 7: Wiring of the system.
Step 8: Preparing for operation
Conclusion:
Personal additions:
Have Fun!
Here are some easy steps to Install the Turbo Kit.
Prepare the Turbo Kit Before Installation
- Remove the turbine housing from the header of the turbo.
- Install the gasket that fits on the header and put the header back on with the appropriate nuts and bolts.
- Install the studs on the turbine housing. The studs should come with the kit.
- Use the smaller gaskets and install the wastegates on the header.
Install Your Turbo Kit
- Connect the oil line to the middle section and tighten the connections. This center section should be rotated so that it is flush with the flange before it is tightened.
- Install the water banjo fittings. The kit should have the necessary bolts and washers for the job.
- Connect the two hoses that came with the kit. Install the shorter hose in back of the turbo and the longer one in front.
- Install the turbo that has been assembled onto the header and tighten all the bolts and nuts.
- Connect the flange to the oil pan, returning the oil line to the flange.
- Install the support bracket to the engine block and tighten by hand.
- Connect the downpipe and dump tubes to the turbo and secure by hand with clamps. The passenger-side dump tube should be connected to the downpipe. The driver-side tube needs to go into the compressor's threaded hole.
- Install the banjo fitting on the head of the cylinder and fasten the water line.
- Attach the remaining water and cooling lines.
Wednesday, October 24, 2012
Subscribe to:
Posts (Atom)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)
.jpg)




