Here are some easy steps to Install the Turbo Kit.
Prepare the Turbo Kit Before Installation
- Remove the turbine housing from the header of the turbo.
- Install the gasket that fits on the header and put the header back on with the appropriate nuts and bolts.
- Install the studs on the turbine housing. The studs should come with the kit.
- Use the smaller gaskets and install the wastegates on the header.
Install Your Turbo Kit
- Connect the oil line to the middle section and tighten the connections. This center section should be rotated so that it is flush with the flange before it is tightened.
- Install the water banjo fittings. The kit should have the necessary bolts and washers for the job.
- Connect the two hoses that came with the kit. Install the shorter hose in back of the turbo and the longer one in front.
- Install the turbo that has been assembled onto the header and tighten all the bolts and nuts.
- Connect the flange to the oil pan, returning the oil line to the flange.
- Install the support bracket to the engine block and tighten by hand.
- Connect the downpipe and dump tubes to the turbo and secure by hand with clamps. The passenger-side dump tube should be connected to the downpipe. The driver-side tube needs to go into the compressor's threaded hole.
- Install the banjo fitting on the head of the cylinder and fasten the water line.
- Attach the remaining water and cooling lines.

No comments:
Post a Comment